Fixing Film Unit; Preparation For Removing The Fixing Film Unit; Removing The Fixing Film Unit - Canon LBP3010 Series Service Manual

Chapter 3
Points to note at installation
When attaching the fixing harness, wind the fixing harness [2] around the
protrusion [1] of the harness holder and secure it with the harness guide [3].
[3]
Points to note at installation
When attaching the terminal [1], make sure that the contact spring [2]
contacts as shown.
[1]
[2]
3-20
[1] [2]

3.5.2 Fixing Film Unit

3.5.2.1 Preparation for Removing the Fixing Film Unit

LBP3100 / LBP3010B
1) Removing the Upper Cover (page 3-2)Reference[Removing the Upper
Cover]
2) Removing the Left Cover (page 3-2)Reference[Removing the Left Cov-
er]
3) Removing the Right Cover (page 3-1)Reference[Removing the Right
Cover]
4) Removing the Rear Cover (page 3-1)Reference[Removing the Rear
Cover]
5) Removing the Main Controller PCB (page 3-9)Reference[Removing the
Main Controller PCB]
6) Removing the Fixing Assembly (page 3-18)Reference[Removing the
Fixing Assembly]

3.5.2.2 Removing the Fixing Film Unit

LBP3100 / LBP3010B
1) Disconnect the connecter [1] and free the harness [3] from the harness
guide [2].
[2] [3]
2) Turn the fixing unit [1] in the arrow [A] and arrow [B] direction in order.
[1]
3) Remove the fixing upper guide [1].
- 2 screws [2]
[1]
F-3-63
[A]
[B]
F-3-64
0019-4355
0019-4356