Line Seizure; Trunk Keys - Siemens HiPath 500 User Manual

Making calls in the team/executive/secretary configuration
Step by Step
94

Line seizure

Line seizure must be configured (consult your service
personnel). If automatic line seizure is configured, a
trunk is automatically assigned when you lift the hand-
set or press the trunk key.

Trunk keys

The programmable keys on multi-line phones function
as line keys. Every sensor key programmed as a "Trunk
key" (key label: Transfer Trk) corresponds to a trunk with
the result that you can configure up to 8 trunks in
OpenStage 30 T .
As a team member, you can independently program the
following functions on keys
• Direct station select
• Join/leave group
(not available on executive phone in an executive/
secretary team)
• Ring Transfer: On/Off
(only in an executive/secretary team)
You can also program a sensor key with the function
"Forward Line" (call forwarding) for each line.
LED displays on trunk keys
LED Explanation
S
Off – The line is in idle mode.
– Incoming call on the line.
T
1
Flashing – Hold reminder is activated.
– The line is on "Hold".
R
On – The line is busy.
[1] In this manual, flashing keys are identified by this icon, regardless
of the flashing interval. The flashing interval represents different
statuses, which are described in detail in the corresponding sec-
tions of the manual.
page 63: