20
Connecting a PTZ Camera (LNR100 Series)
2. Click Set to open the action setup menu.
3. Select Pattern.
4. Under Pattern, enter the pattern you would like to configure.
5. Click Begin to save the current camera position as the beginning of the pattern.
6. Right-click to return to the PTZ controls, and move the camera into the desired end
position.
7. Click Set to go back to the action setup menu, and click End to save the current cam-
era position as the end of the pattern.
To run a pattern:
1. Press Page Switch to get to the call action page.
2. Under No., select the number of the pattern you would like to run and click Pattern.
3. Click Stop to stop the pattern.
20.2.4 Auto Scan
Auto scan automatically cycles between a left and right point.
#; r. 1.0/14396/14396; en-US
162