Central Machinery 60500 Owner's Manual & Safety Instructions page 7

Assembly
1. Unpack the Table (8) and remove
the protective cover.
2. Slide the slot in the Table (8) around the Blade.
Position the Table (8) onto the
Saw over the two posts.
Then, pull out and release the Tilt Knob (19)
to help align the Table.
connect
Tilt Lock ( 12 )
here
Tilt Knob ( 19 )
Item 60500
Indicator
Screw ( 119 )
Tilt
Indicator ( 117 )
For technical questions, please call 1-800-444-3353.
3. Secure the Table (8) using Tilt Lock (12) and
Flat Washer (13) through the hole shown above.
Leave the Tilt lock slightly loose for now.
4. Use a square (sold separately) to set Table (8)
perpendicular (90° angle) to Saw Blade (111) and
tighten the Tilt Lock (12) to secure the Table in place.
5. Loosen the Indicator Screw (119), turn the
Tilt Indicator (117) around to face the scale,
align the Tilt Indicator to 0° on the scale, and
hold it still while tightening the Indicator Screw.
6. Remove the Table Insert (9) from the Wing Bolt (11).
Insert the Insert into the end of
the slot on the Table (8).
Insert the Wing Bolt and Spring Washer (10)
up through the slot and into the
Table Insert (9) and tighten to secure.
Table
Insert ( 9 )
Wing Bolt ( 11 )
Table ( 8 )
Spring Washer ( 10 )
Page 7