Pride Mobility Quantum 1103 Ultra Series Owner's Manual page 30

V . C O M F O R T
Power Elevating Seat Operation
If your power chair is equipped with a power elevating seat,
you can change the seat height either through the controller
or through a toggle switch mounted to one of the armrests.
See figure 23.
NOTE: For information on how to raise and lower
your seat through the controller, contact your Quan-
tum Rehab Specialist.
To operate the power elevating seat:
1. Bring your power chair to a complete stop.
2. Push the toggle switch forward to raise the seat or pull
the switch rearward to lower the seat. When you re-
lease the switch, the seat will stop.
NOTE: The power elevating seat system has an upper
and a lower limit of travel. Once the actuator reaches
either one of these limits, you should continue to hear
and/or feel the actuator motor running. This is be-
cause there is a clutch mechanism that allows the
motor to continue running after the actuator has
reached its limit. This clutch works at both the top
and bottom extensions of the lift.
WARNING! Do not allow the motor to run
more than a few seconds after the
mechanism reaches the top or bottom
limit. This can damage the motor.
The power elevating seat is equipped with a swivel feature
that allows the seat to be turned 90 degrees to whichever
side the controller is located.
To use the swivel feature:
1. Locate the friction lock lever under the seat. See figure 11.
2. Pull back the friction lock lever to rotate the seat in 90° increments.
3. Pull the friction lock lever forward to lock the seat in place.
WARNING! Do not attempt to drive the power chair with the seat facing to the side. Always return
the seat to the forward facing position before operating the power chair.
30
A D J U S T M E N T S
Figure 23. Power Elevating Seat Toggle Switch
www.quantumrehab.com Quantum 1103 Ultra Series