Panasonic LUMIX DMC-FS42 Operating Instructions Manual page 151

[READ ERROR PLEASE CHECK THE CARD]/
[WRITE ERROR PLEASE CHECK THE CARD]
• It has failed to read or write data.
Turn the camera off and remove the card. Insert the card again, turn the power on,
and try to read or write the data again.
• The card may be broken.
Insert a different card.
[MOTION RECORDING WAS CANCELLED DUE TO THE LIMITATION OF THE
WRITING SPEED OF THE CARD]
• When you set the picture quality to [WVGA] or [VGA], we recommend using a high-
speed card with "10 MB/s" or greater displayed on the package.
• If the operation stops even if you use the card with memory size of 10 MB/s or greater,
this means the data-writing speed has lowered. We recommend backing up the data and
formatting the card. (P27)
• Depending on the type of SD Memory Card or SDHC Memory Card, motion picture
recording may stop in the middle.
[A FOLDER CANNOT BE CREATED]
• A folder cannot be created because there are no remaining folder numbers that can be
used. (P98)
Format the card after saving necessary data on a PC etc. (P27)
[PICTURE IS DISPLAYED FOR 4:3 TV]/[PICTURE IS DISPLAYED FOR 16:9 TV]
• The AV cable is connected to the camera.
Press [MENU/SET] if you want to delete this message at once.
Select [TV ASPECT] in the [SETUP] menu to change the TV aspect. (P27)
• This message also appears when the USB connection cable is connected to the camera
only. In this case, connect the other end of the USB connection cable to a PC or a
printer. (P96, 99)
[PRINTER BUSY]/[PLEASE CHECK THE PRINTER]
• The printer cannot print.
Check the printer.
[NO BATTERY POWER REMAINS]
• The remaining battery power is low.
Charge the battery.
[THIS BATTERY CANNOT BE USED]
• The battery cannot be recognized by the camera.
Use a genuine Panasonic battery. If this message is displayed even when a genuine
Panasonic battery is used, contact the dealer or your nearest Service Center.
• The battery cannot be recognized as its terminal is dirty.
Remove any dirt etc. from the terminal.
Others
- 117 -