Table of Contents
Advertisement
Advanced settings
The following functions (Parmeter)
are available:
Function no.
01
02
03
04
05
06
07
13
14
20
21
22
23
24
TF 601
TOSHIBA
Function
ECM
CONFIRMATION OFF
REPORT VISUAL ON
HEADER PRINT
RECEIVE FOOTER
XMT SPEED
RCV SPEED
RDC ACCEPTANCE
RDC CENTER ID
DIAL METHOD TONE
REDIAL TIMES
REDIAL INT.
TRAIN INT.
BUSY TONE
Description
Error correction (ECM) is as follows:
ON:
Activated
OFF:
Deactivated
Transmission report is produced:
ON:
After every transmission
CONFIRMATION OFF: Only after
transmission errors.
A part of the document (to recognize it)
can be printed on the report.
REPORT VISUAL ON: print
REPORT VISUAL OFF: print not
Select, if the TX header will be
transmitted to te other party.
ON:
Is transmitted
OFF:
Is not transmitted
Select, if the actual date and time will be
printed on the footer line of received
documents.
ON:
Is printed
OFF:
Is not printed
Preset transmission speeds, transmission
BPS = BIT / Sec.
9600 BPS, 7200 BPS, 4800 BPS, 2400 BPS
Preset transmission speed, reception
BPS = BIT / Sec.
9600 BPS, 4800 BPS
Telediagnosis via the telephone line. The
function must be enabled by the owner of
the fax machine due to considerations of
data protection.
When active: Reactivation necessary
after the Comline action
ON:
Comline not always possible
OFF:
Comline never possible
Do not change this setting.
Dialling method:DTMF
PULSE DIALLING
Number of redial attempts if transmission
is not successful
02
2 twice
~
10
10 times
Period between redial attempts if
transmission is not successful
30 SEC
30 seconds
~
1 MIN
2 MIN
3 MIN
10 MIN
20 MIN
20 minutes
Period between redial attempts if line is
busy
1 MIN
1 minute
~
10 MIN
10 minutes
The successful detection depend on the
PBAX.
ON:
active
OFF:
not active
49
Advanced settings
GB
Advertisement
Table of Contents
