3Com 6000 series Getting Started Manual page 52

52 Chapter 5: Router Software Maintenance
Download file(Max 60 char)
IP address of eth0
Subnet mask for eth0
IP address of the server
IP address of the gateway
Saving the net configuration, are you sure?[Y/N]
Table 8 Description on the download parameters
Parameter
Download device
Download file (Max 60 char)
IP address of eth0
Subnet mask for eth0
IP address of the server
IP address of the gateway
Press <Y> to save the configuration.
4 When Net Port Download Menu appears, select option 2 to download
and write the application image to Flash memory. The system displays:
Starting the TFTP
download..................................................
TFTP download completed.
File length = [07600856]
Writing program code to FLASH...
Please wait, it may take a long time...........................................................
Writing into Flash Successfully!
Now, the system returns to Net Port Download Menu.
If you select option 3 in the menu to directly download the program to
the SDRAM and run it there, the downloaded application image cannot
survive a reboot because the file is not written to Flash memory.
Upon completion of application image upgrade, the router reboots and
checks Boot ROM version for consistency before starting the Comware
3.11 software. If the version of the current extended Boot ROM image
:vrp.bin
:1.1.1.11
:255.0.0.0
:1.1.1.10
:
Description
The Ethernet port for downloading, which must be
eth0.
Name of the Comware 3.11 file to be downloaded.
IP address of interface eth0.
Subnet mask of interface eth0.
IP address of the server where Comware 3.11 is
retained.
You must configure it if the server and the router
are not located on the same segment.