Tools And Equipment; Unpacking And Verifying Shipping Contents; Checking The Shipping Container Contents - Cisco ASR 1001-X Installation Manual

Chapter 3 Preparing Your Site for Installation

Tools and Equipment

The following tools and equipment are recommended as the minimum necessary equipment to install the
Cisco ASR 1001-X Router. You may need additional tools and equipment to install associated equipment
and cables. You may also require test equipment to check electronic and optical signal levels, power
levels, and communications links.
•
•
•
•
•
•
•
•

Unpacking and Verifying Shipping Contents

When you receive your chassis, perform the following steps and use the shipping contents checklist from
"Checking the Shipping Container Contents" section on page
Inspect the box for any shipping damage. (If there is damage, contact your Cisco service representative).
Step 1
Unpack the Cisco ASR 1001-X Router.
Step 2
Step 3 Perform a visual inspection of the chassis.
Step 4 After you have unpacked the system, verify that you have received all of the required components,
including all the accessory items. Using the packing list as a guide, verify that you have received all the
equipment listed in your order, and ensure that the configuration matches the packing list.

Checking the Shipping Container Contents

Use the components list shown in
shipping container. Do not discard the shipping container. You need the container if you move or have
to ship the Cisco ASR 1001-X Router in the future.
Table 3-7
Component
Chassis
OL-32376-02
Phillips hand screwdriver
3.5-mm flat-blade screwdriver
Tape measure (optional)
Level (optional)
Power drill
8-gauge wire
Rack-mount brackets
Cable-management brackets
Cisco ASR 1001-X Router Shipping Container Contents
Description
Cisco ASR 1001-X Routers are configured with dual AC or dual DC
power supplies and a shared port adapter and NIM blank panel if a shared
port adapter or NIM has not been ordered.
Table 3-7 to check the contents of the Cisco ASR 1001-X Router
Cisco ASR 1001-X Router Hardware Installation Guide
Tools and Equipment
3-19.
3-19