Error Displays; Specifications - Clarion CZ603AU Owner's Manual & Installation Manual

Bluetooth cd/usb/mp3/wma receiver
Table of Contents

Advertisement

7. ERROR DISPLAYS

If an error occurs, one of the following displays is displayed.
Take the measures described below to solve the problem.
Display
Cause
Disc is inserted incorrectly.
ERROR 3
The disc format is not supported.
ERROR 5
This is a failure of deck's mechanism.
If an error display other than the ones described above appears, press the
problem persists, turn off the power and consult your store of purchase.
* When the
[RESET]
button is pressed, frequencies of radio stations, titles, etc. stored in
memory are cleared.
16
Measure
Eject the disc then reload it properly.
Try another disc.
Consult your store of purchase.
[RESET]
button. If the

8. SPECIFICATIONS

FM Tuner
Frequency range: 87.5-108MHz
Usable sensitivity: 8dBf
Frequency response: 30Hz-15kHz
Stereo separation: 30dB(1kHz)
Signal/noise ratio: >55dB
AM Tuner
Frequency range: 531-1629kHz
Usable sensitivity (S/N=20dB): 30dBμ
CD Player
System: Disc digital audio system
Frequency response: 20Hz-20kHz
Signal/noise ratio: >94dB
Total harmonic distortion: Less than 0.1% (1kHz)
Channel separation: >60dB
MP3/WMA mode
MP3 sampling rate: 8 kHz to 48 kHz
MP3 bit rate: 8 kbps to 320 kbps / VBR
WMA bit rate: 8 kbps to 320 kbps
Logical format: ISO9660 level 1,2
USB
Playable audio format:
MP3(.mp3): MPEG 1/2/Audio Layer-3
WMA(.wma): Ver 7/8/9.1/9.2
Bluetooth
A2DP (Advanced Audio Distribution
Send/Receive Sensitivity: Class 2
Maximum power output:
200W (50W x 4)
Speaker impedance: 4
(4 to 8
allowable)
Input
Audio input sensitivity:
High: 320mV (at 2.5V output)
Mid: 650mV (at 2.5V output)
Low: 1.3V (at 2.5V output)
(input impedance 10 k
or greater)
Aux-in level: ≤2V
General
Power supply voltage:
14.4VDC (10.8 to 15.6V allowable),
negative ground
Pre-Amp output voltage:
5.0V (CD play mode: 1kHz, 0dB, 10k
load)
Fuse: 15A
Dimensions of the Main Unit:
188mm Width × 58mm Height × 190mm Depth
7-2/5(width) × 2-7/25(Height) × 7-12/25(Depth)
Weight of the Main Unit: 3.1lb. (1.40kg)
Dimensions of the Remote Control unit:
43mm Width × 11mm Height × 113mm Depth
1-2/3(Width) × 2/5(Height) × 4-2/5(Depth)
Weight of the Remote Control Unit:
1.16oz. (36g) (including battery)
7" 178mm
2"
50mm
1-4/5"
46mm
6-2/3" 170mm
2-7/25" 58mm
7-2/5" 188mm
Note:
• S
without notice for further improvement.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents