Table of Contents
Advertisement
Display Assembly and Display Latch: Dell Latitude V710/V740 Service Manual
1 top cover
2 M2.5 x 5-mm screws (2)
3 bottom case
1. Remove the keyboard.
2. Close the display assembly.
3. From the back of the computer, remove the two M2.5 x 5-mm screws labeled "circle D."
4. Open the display assembly approximately 180 degrees and support the display assembly
so that it does not open past this position.
5. Remove the two M2.5 x 5-mm screws that secure the display-feed flex cable to the
system board.
NOTICE:
When reconnecting the display-feed flex cable connector to the system board,
push down on the top left and right ends of the connector. Pressing on the center of the
connector may damage resistors and compromise EMI protection in the computer.
file:///F|/Service%20Manuals/Dell/Latitude/v710-740/display.htm (2 of 10) [2/28/2004 8:22:14 AM]
Advertisement
Table of Contents
