Fd Circuit Board - Yamaha 01v 96 Service Manual

01V96
12.

FD Circuit Board

(Time required: About 5 minutes)
12-1. Remove the seventeen (17) fader knobs from the
control panel side. (Photo.15)
12-2. Fasten the control panel assembly. (See procedure 1.)
12-3. Remove the ten (10) screws marked [210]. The FD
circuit board can then be removed with the insulation
sheet. (Photo.16)
12-4. Remove the four (4) cord holders. The insulation
sheet can then be removed from the FD circuit board.
(Photo.16)
The insulation sheet is fastened to the FD
circuit board by the cord holders.
When you replace the FD circuit board, be sure
to attach the insulation sheet as before.
<Top view>
[270] [270] [270] [270] [270] [270]
[270]: Bonding Tapping Screw-B
3.0X8 MFZN2BL (VN413300)
[280]: Hexagonal Nut
9 12X2 MFNI3 (VP034300)
Photo.11
<Bottom view>
Soldering
Photo.13
28
[280] x 28
[270]
[280]
HA
<Bottom view>
ADA
[260]
[260]: Bind Head Tapping Screw-B
3.0X8 MFZN2BL (EP600190)
Photo.12
<Top view>
HA
Phone cannon shield
Cannon connector x 12
Photo.14
HA
Phone jack x 12