Ac Circuit Board; Ac Inlet Assembly - Yamaha 01v 96 Service Manual

01V96
8.

AC Circuit Board

(Time required: About 5 minutes)
8-1. Fasten the control panel assembly. (See procedure 1.)
8-2. Remove the AC shield plate. (See procedure 6.)
8-3. Remove the cord holder fastened the AC circuit
board and the ferrite core.(Photo.5)
8-4. Remove the two (2) screws marked [145]. The AC
circuit board can then be removed from the two (2)
locking card spacers. (Photo.5)
The power switch knob is not part of the AC
circuit board. When you replace the AC circuit
board, you should remove the power switch
knob from the AC circuit board, and install in
the new AC circuit board. (Photo.6)
9.

AC Inlet Assembly

(Time required: About 5 minutes)
9-1. Fasten the control panel assembly. (See procedure 1.)
9-2. Remove the AC shield plate. (See procedure 6.)
9-3. Remove the cord holder fastened the AC inlet
assembly and the ferrite core.(Photo.8)
9-4. Remove the two (2) screws marked [165] and the
screw marked [175]. The AC inlet assembly can then
be removed. (Photo.7, 8)
Ferrite core
Locking card spacer
[145]: Bind Head Tapping Screw-B
3.0X6 MFZN2BL (EP600230)
[165]: Bind Head Tapping Screw-B
3.0X8 MFZN2BL (EP600190)
Photo.7
26
Cord holder (underneath the ferrite core)
AC
Photo.5
[165]
[145]
Ferrite core
Cord holder
[175]
[175]: Bind Head Tapping Screw-S
4.0X8 MFZN2BL (VI693100)
Photo.8
Power switch knob
Photo.6
AC inlet assembly