Accessories - Bosch CM8S Operating/Safety Instructions Manual

BM 2610025580 05-13_BM CM8S 5/17/13 1:37 PM Page 44
pROBlEM
Tool vibrates or shakes.
Head assembly does not slide
freely when attempting a slide cut.
Blade does not cut completely
through workpiece.
Saw blade or lower guard cuts or
contacts sliding fence when saw is
set for bevel cuts.
DAf220K Miterfinder™
finder/Compound Cut Calculator/protractor/level
– Gives you the information needed to position cuts
so that they fit together precisely even if the room is
out of square.
MS1233 Crown Stop Set – Correctly hold crown
molding in an inclined position against fence. Set
molding for simple vertical cutting – no compound
cutting required.
Troubleshooting
Troubleshooting Guide - General
CAUSE
1. Saw blade not round.
2. Saw blade damaged.
3. Saw blade loose.
4. Other
Slide rail lock knob is engaged.
1. Depth stop plate is pulled out for
non-through cuts.
2. Replacement blade is less than
8 ⁄ " diameter.
1
2
Sliding fence is not moved out from
path of saw blade before making
bevel cut.

Accessories

Digital Angle
CORRECTIVE ACTION
- Replace blade.
- Replace blade.
- Check that blade is properly
seated on the inner washer. See
Removing and Installing Blades
on page 13.
- Authorized service.
Rotate slide rail lock knob counter
clockwise to disengage.
- Push depth stop plate inward to
set for full-depth cuts
(see page 16).
- Change to a blade that is fully
8 ⁄ " diameter.
1
2
Move sliding fence to be clear of
lower guard and saw blade;
perform a "dry cut" to check for
clearances before making bevel
cuts (see page 26).
GTA3800 portable Stand with Wheels
T4B Gravity-Rise Wheeled Miter Saw Stand
MS1234 length Stop
44.