Attaching Loose Parts - Bosch CM8S Operating/Safety Instructions Manual

BM 2610025580 05-13_BM CM8S 5/17/13 1:37 PM Page 12
WARNING
source before
adjustments or repairs.
Storing the 5mm Hex Key
There is a storage location on the saw to store the
5mm hex key. Insert the short leg of the hex key
through the rubber grommet as shown. Rotate long
leg under hook (see figure 1).
NOTE: The 5mm hex key is needed to change the
blade and to make tool adjustments.
Attaching 60˚ Auxiliary clamp hole
1. Position the 60˚ auxiliary clamp hole as shown in
figure 2.
2. Insert the screws provided into holes and tighten
with Philips screwdriver.
The 60˚ auxiliary clamp hole is used to appropriately
clamp material at angles from 55 ˚to 60˚ right see
page 25 for clamping instructions.
Assembly

Attaching loose parts

To avoid possible
disconnect plug from power
performing any assembly,
injury,
FIG. 1
FIG. 2
Auxiliary
Clamp Hole
12.
Hook
Grommet
Mounting
Screws
5mm
Hex Key