Stopping The Treadmill; Safety Sentry - CYBEX 770T Owner's Manual

Stopping the Treadmill

Press Stop once to end the workout session and start the Workout Review. The treadmill will perform
a controlled belt stop and bring the incline to 0%. The accumulated data or the results of the Fitness
Test will be displayed for the duration configured in Setup for Review Time. Press Stop again to exit
to Dormant.
The function of the immobilization method: The purpose of immobilizing the treadmill is to prevent
unauthorized use. This can be accomplished by removing the e-stop key from the treadmill, un-
clipping it from the cord and putting it in a non-accessible place.
The emergency dismount: Follow the steps listed below if you experience pain, feel faint or need to
stop your treadmill in an emergency situation:
1. Grip handrails for support.
2. Step onto the top steps.
3. Pull the e-stop key off the console.
The function of the emergency stop: The e-stop key functions as the emergency stop. In an
emergency situation, remove the e-stop key from the treadmill and the running belt will come to a
stop.

Safety Sentry

WARNING: Falling hazard
Place your feet on the two top steps when starting or stopping the treadmill.
•
Wear the e-stop clip at all times.
•
The treadmill uses sensors to determine if you are on the running belt. When using the treadmill,
exercise in the center of the running belt, and between the end of the handrails and the console. If
you step off of the treadmill during a workout, the treadmill is designed to detect your absence and if
a user is not detected, the console will beep twice and display "Are you there? Touch the screen to
continue". If there is no response in 20 seconds, the treadmill will exit Active Mode and the running
belt will stop.
Cybex Owner's Manual
51