Note For Repair; Lcd Type Check - Sony DCR-TRV820 Service Manual

3.

NOTE FOR REPAIR

Make sure that the flat cable and flexible board are not cracked of
bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
Cut and remove the part of gilt
which comes off at the point.
(Be careful or some pieces of
gilt may be left inside)
4.

LCD TYPE CHECK

By measuring the resistor value between Pin 6 of CN5502 and
Pin 0 of CN5502 on PD-118 board, the type of LCD can be dis-
criminated.
Note: About PD-118 board and LCD module, discriminate LCD
type on the machine, and replace the same type.
PD-118 board CN5502
Resistor
LCD type
value
8.2 kΩ TYPE S
10 kΩ TYPE C
PD-118 board
PD board
PD-118 (TYPE S)
PD-118 (TYPE C)
Volt ohm meter
CN5502
Multi CPC jig
(J-6082-311-A)
6 pin
0 pin
When remove a connector, don't pull at wire of connector.
It is possible that a wire is snapped.
When installing a connector, don't press down at wire of connector.
It is possible that a wire is snapped.
– 8 –