I Receiving And Transmitting - Icom IC-M601 Instruction Manual

I Receiving and transmitting

q Push [PWR] to turn power ON.
w Push [VOL], then [Y]/[Z] to adjust audio output level.
• Push [SQL], then [Y]/[Z] to mute any audio noise, if necessary.
e Push [Y]/[Z] to select the desired channel.
• When receiving a signal, "
from the speaker.
• Further adjustment of audio level may be necessary at this point.
r Push [H/L] to select the output power, if necessary.
• "LOW" appears when low power is selected.
• Choose low power to reduce an intermodulation for other sta-
tions, choose high power for longer distance communications.
• Some channels are low power only.
t Push and hold [PTT] to transmit, then speak into the mi-
crophone.
• " " appears.
• Channel 70 cannot be used for transmission.
y Release [PTT] to receive.
IMPORTANT: To maximize the readability of your trans-
mitted signal (voice), pause a few sec. after pushing [PTT],
hold the microphone 2.5 to 5 cm from your mouth and
speak at a normal voice level.
" appears and audio is emitted
HM-134 REMOTE-CONTROL MICROPHONE
q Turn power ON
t Push to
transmit
y Release
to receive
e Set channel
13
r Set output power
w Set volume
w Set squelch,
if required
t Speak into
microphone
13
53