Checking The Propeller Shaft Housing Assembly - Yamaha 200A Service Manual

LOWR
2. Remove the ball bearing.
Stopper guide stand 2:
90890-06538
Bearing puller assembly 3:
90890-06535
Bearing puller claw 1 4:
90890-06536
3. Remove the oil seal. Also remove the
needle bearing.
NOTE:
When the oil seal or the needle bearing is re-
moved, always replace them with new ones.
Driver rod L3:
90890-06652
Needle bearing attachment:
90890-06653
Shimming is required when the reverse
gear, ball bearing, or propeller shaft hous-
ing is replaced.
6-13
Lower unit
60h60150
60h60160
Checking the propeller shaft housing
assembly
1. Clean the propeller shaft housing, and
check it for cracks, corrosion, or damages.
Replace if necessary.
2. Check the teeth and dogs of the reverse
gear for cracks or wear. Replace the gear
if necessary.
60h60170
60h60180
60H5E11