Table of Contents
Advertisement
5. Adjustment Method
"** This Adjustments should be done by using SVC Remote Controller ""R-30SVC6"""
MICOM PROGRAMMING
-Micom should be programmed by using PC with operation tests.
-The specific s/w and adapter are needed for micom programing.
SCREEN Adjustment
(1) Press the SVC key of the SVC remote controller ( R-30SVC6)
(2) Adjust Screen Volume of FBT until the horizontal line is just disappeared.
(3) Press the Screen key on the SVC remote controller to release Screen mode.
FOCUS Adjustment
-Adjust with the Focus volume on the FBT until you get the most clear resolution of 350
line and corner of screen.
WHITE BALANCE Adjustment
(1) Measuring instrument settings
-The others are same with other chassis
-NITSUKI have to be set exactly to Reference G, CHROMA : OFF
-The Reference coordinates : HIGH ( x : 288, y : 301, Y : 100cd/m2)
(2) High-Beam Adjustment
-Adjust with R DRV +/-, B DRV +/- keys so that only R,B bars in the high beam on the
instrument may be located in the center. ("G" DRIVE is Fixed.)
(3) Low-Beam Adjustment
-Adjust with R BIAS +/-, B BIAS +/- keys so that only R,B bars in the low beam on the
instrument may be located in the center. ("G" DRIVE is Fixed.)
VERTICAL CENTER Adjustment
-Pattern : RETMA
-Adjust with V-CEN +/- keys to harmonize pattern's upper marking with Lower marking.
(ex) "2/2" or "3/3" or "1/1"
VERTICAL SIZE Adjustment
-Pattern : RETMA
-Adjust with V-SIZE +/- keys so that the upper and the lower '3' marks of the RETMA
pattern may be located at the boundaries of the screen.
Horizontal Center Adjustment
-Pattern : RETMA
-Adjust with H-CENTER +/- keys to harmonize the position of pattern's Left side with
Right side.
LOW ( x : 288, y : 301, Y : 15cd/m2)
8
Advertisement
Table of Contents
