TABLE OF CONTENTS
............................................................. 2
........................................................................ 3
.............................................................. 14
6-1. Test Mode ........................................................................ 17
• Tuner Section ................................................................ 17
7.
8.
9.
Please press on the sub board from above when checking it.
This assures that the connector does not lose contact.
2
................ 15
............................ 17
................................................ 32
............................... 35
SECTION 1
SERVICE NOTE
SUB board
Flexible Circuit Board Repairing
• Keep the temperature of the soldering iron around 270 ˚C dur-
ing repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
Front panel assembly