How To Operate The Machine; How To Start/Stop The Machine; How To Control The Machine; Maintenance - Clarke 01207SD Operator's Manual

ENGLISH
EN

HOW TO OPERATE THE MACHINE

How To Start/Stop The Machine

WARNING: Never start a polisher when
the handle is in the vertical
position.
The following steps apply to MP-1800:
The switch to start and stop the machine is activated
by the interlock switch (1) and the levers (2) under the
handle grips. See figure 5.
To start the machine, follow this procedure:
1. Lower the handle
2. Lock the handle in the best position for operation.
NOTE: Make sure you hold the handle with both
hands.
3. Push the interlock switch (1), and apply pressure to
the levers (2). See figure 5.

How To Control The Machine

NOTE: Make sure you hold the handle with both
hands.
The side to side movement of the machine is controlled
by raising the handle and pressing down on the handle.
To move the machine to the left, press down on the
handle slightly. To move the machine to the right, raise
the handle slightly.

MAINTENANCE

WARNING: Maintenance must be done
by authorized personnel
only.
Maintenance Instructions
Return the machine to a Clarke Authorized Service
Location every 12 months for maintenance inspections.
-8- FORM NO. 71399A
1
2
Figure 5
Clarke
2
® MP-1800 - (EN)