How To Operate The Machine - Clarke American Sanders RS-16 HDTR Operator's Manual

ENGLISH
EN

HOW TO OPERATE THE MACHINE

OPERATION (Figure 4)
1 Unwrap the Power Cord (5) and plug it into a properly grounded
outlet.
2 Pull up on the Handle Release Compression Lever (4). Move
the Operator Handle (6) downward until your arms are almost
straight. Push down on the Handle Release Compression Lever
(4) to lock it in place.
3 Lift up on the Operator Handle (6) until the brush (or pad) is fl at
against the fl oor.
WARNING! Be prepared to control the machine
as soon as the motor starts. Just a slight up
or down movement of the Handle will make
the machine move from side to side. Raise the
Handle to go right. Lower the Handle to go left.
CAUTION! Immediately start moving the
machine back and forth. Keep the machine
moving while the motor is running to avoid
damage to the fl oor.
4 Hold one of the Operator Hand Grips (1) fi rmly, push the Safety
Lock Button (2) and then compress the Switch Levers (3) to start
the motor. NOTE: When the Switch Levers (3) are released, the
machine shuts off immediately.
AFTER USE (Figure 4)
1 Place the Operator Handle (6) in the upright position and unplug
the Power Cord (5). Wrap the Power Cord (5) around the Opera-
tor Handle Grips (1) and the Cord Hook (7).
2 Remove the pad driver from the machine. Never store the
machine with the pad driver on the machine.
3 Wipe the entire machine with a clean, damp cloth.
4 Inspect the entire machine and all accessories for damage.
Perform any required maintenance or repairs before storage.
5 Store the machine in a clean, dry place with the Operator Handle
(6) locked in the upright position.
-8-
1
2
4
®
Clarke American Sanders Operator's Manual (EN) - RS-16 HDTR
3
6
7
5
Figure 4