Service Interval Display - Skoda Fabia Owner's Manual

The speed limit set mode is stored even after the ignition is switched off and
on.

Service Interval Display


Introduction
This chapter contains information on the following subjects:
Prompt in the segment display
Display in the MAXI DOT display
A message concerning the kilometres and days remaining until the next
service is due is shown for about 10 seconds after the ignition is switched on
until the end of the service interval is reached.
The kilometre indicator or the days indicator reduces in steps of 100 km or
days until the service due date is reached.
Resetting the oil change service indicator in a specialist dealer's
For vehicles with variable service intervals, after resetting the screen displays,
the values of a new service interval is displayed, which are based on the previ-
ous operating conditions of the vehicle.
These values are then further continuously matched according to the actual
operating conditions of the vehicle.
Note
Information is retained in the Service Interval Display even after the vehicle
■
battery is disconnected.
If the instrument cluster is exchanged after a repair, the correct values must
■
be entered in the counter for the Service Interval Display. This work will be
done by a specialist garage.
For more information on the service intervals, see the
■
ter service schedules.
32
Using the system
Prompt in the segment display
32
33
Oil change service
If an oil change service is due, the  icon and the number 1 is displayed at the
position identified with the arrow for approximately 10 seconds
The  icon is shown together with the days and kilometres remaining to the
next service.
As soon as the service due date is reached, the flashing  icon and the mes-
sage OIL CHNG appears in the display for about 20 seconds after the ignition is
switched on.
Inspection
If an inspection is due, the  icon and the number 2 are displayed at the posi-
tion identified with the arrow for approximately 10 seconds
The  icon is shown together with the days and kilometres remaining to the
next service.
As soon as the due date for the service is reached, the flashing  icon and the
INSPEC _ message appear in the display for about 20 seconds after the igni-
tion has been switched on.
» Serviceplan, chap-
Display the days and distance until the next service
You can press button
ing distance and time to until the next service whenever the ignition is switch-
ed on.
The  icon appears together with the  icon and the distance and time to the
next service appear in the display for about 10 seconds.
The distance and the days remaining until the next oil change service are dis-
played first; the distance and the days remaining until the next inspection are
displayed after the button
Fig. 23
Example of a message
» Fig. 19 on page 26 repeatedly to display the remain-
5
is pressed again.
5
» Fig. 23.
» Fig. 23.
