Sony SR-R1000 Operation Manual page 54

Button Indication
ALT/[F8] PREROLL
ALT/[F9] REC INHI
ALT/ REMOTE CONFIG Makes advanced settings regarding Remote control.
[F10]
[F1] REMOTE SLOT
[F1]
9PIN 1
[F2]
9PIN 2
[F3] 9PIN 3
[F4]
9PIN 4
[F10] EXIT
[F2]
REMOTE PROTCL Selects the protocol to be used for each Remote (9P) connector.
[F1]
9PIN 1
[F2] 9PIN 2
[F3]
9PIN 3
[F4]
9PIN 4
[F10] EXIT
[F3]
REMOTE FILELIST Selects return information for file information sense commands made with each
[F1]
9PIN 1
[F2] 9PIN 2
[F3]
9PIN 3
[F4]
9PIN 4
[F10] EXIT
[F10]
EXIT
54
Detailed Menu Description
Setting
Sets the preroll time. This can be set in 1 second increments.
To make the setting, press the ALT/[F8] buttons, use the cursor buttons or MULTI
CONTROL knob to set the value, and then press the ALT/[F8] buttons again.
0 to 5 sec to 30 sec
Sets record inhibit mode.
Off: Enables recording.
All: Setting record/delete/flag is inhibited for all SRMemory cards.
When "All" is set, the numbers of all slots is displayed in red on the right side of the
write-protect mark on the status bar.
Sets association between Remote (9P) connectors and SRMemory card slots.
Selects the relevant slot when executing commands in a form not specifying a slot.
Slot1: Associates slot M1.
Slot2: Associates slot M2.
Slot3: Associates slot M3.
Slot4: Associates slot M4.
Sets REMOTE (9P) -1 association
Sets REMOTE (9P) -2 association
Sets REMOTE (9P) -3 association
Sets REMOTE (9P) -4 association
Returns to the original menu.
VTR/Disk: Sony VTR protocol and Sony Disk protocol
VDCP: VDCP protocol
Odetics: Odetics protocol
Sets REMOTE (9P) -1 protocol
Sets REMOTE (9P) -2 protocol
Sets REMOTE (9P) -3 protocol
Sets REMOTE (9P) -4 protocol
Returns to the original menu.
Remote (9P) connector.
All: All file information
Playable A: Information on files playable in port A
Playable B: Information on files playable in port B
Playable C: Information on files playable in port C
Playable D: Information on files playable in port D
Editable A: Information on files that can be switched smoothly during playback in
port A.
Editable B: Information on files that can be switched smoothly during playback in
port B.
Editable C: Information on files that can be switched smoothly during playback in
port C.
Editable D: Information on files that can be switched smoothly during playback in
port D.
Only ports running as output ports can be selected.
Sets REMOTE (9P) -1 return information
Sets REMOTE (9P) -2 return information
Sets REMOTE (9P) -3 return information
Sets REMOTE (9P) -4 return information
Returns to the original menu.
Returns to the original menu.
Target
Unit
Unit
Unit
Unit
Unit
Unit
Unit
Unit
–
Unit
Unit
Unit
Unit
Unit
–
Unit
Unit
Unit
Unit
Unit
–
–