Sony SR-R1000 Operation Manual page 31

In such a case, the file's time code can be output while
being converted in accordance with the running frame
frequency.
a Starting TC
The standard time code when being converted.
b Jumping TC
A midway point when the time code is being converted in
a positive or negative direction based on the Starting TC.
The time code will be discontinued before or after this
point.
c Current TC
The current value of the time code. The time code is
displayed after the conversion.
The time code of the file being played is displayed when
the time code is not converted.
The following table demonstrates the discontinuity of a 25
frame time code when the running frequency is 25 frames;
the playback file is 24 frames; and the Starting TC is set to
01:00:00:00 and the 24F Jumping TC to 22:00:00:00
(JUMP TC = -3H).
a Starting TC
c Current TC
b Jumping TC
To make time code conversion settings
With the output port selected, press ALT/[F2] (TC CONV)
in the TC menu.
The one-port display appears and the time data display
area changes to the time code conversion screen.
The normal screen is redisplayed when [F10] (Exit) or the
PORT SELECT button is pressed.
24 Frames TC 25 Frames TC
JUMPING TC 22:00:00:00
:
01:00:01:01
Forward direction 01:00:01:00
M :
STARTING TC 01:00:00:00
m 00:59:59:23
Reverse direction :
22:00:00:01
JUMPING TC 22:00:00:00
To preset the Starting TC with numeric
buttons
Press the [F1] (START TC) key.
The Start TC setup screen is displayed and the Start TC
and Jumping TC displays turn orange. The numerical
value at the left end of the Starting TC display will start to
blink, so similar to TC Preset set the value with the
numeric buttons and confirm this with the SET key.
20:09:36:00
:
01:00:01:00
01:00:00:24
:
01:00:00:00
00:59:59:24
:
22:07:12:01 Non-
consecutive
part
21:09:36:00
31
Time Code Settings