Table of Contents
Advertisement
TRENDnet User's Guide
EVENT CONFIGURATION
© Copyright 2014 TRENDnet. All Rights Reserved.
Event Configuration >> Motion Detection
Area Setting: Click Area 1 /Area 2/Area 3 icon then draw the motion detection area
on the live screen. If there is any motion detected in these areas, the "Motion!"
wording will show on the live screen. To clean the motion detection area, click Area
1 /Area 2/Area 3 icon again.
Sensitivity: Select motion detection sensitivity from 1 to 10.
Trigger Action (Area 1, Area 2, Area 3): When motion is detected, the camera can
send video or snapshot to Email, FTP, Output device and Samba.
Note: Due to network/Internet bandwidth constraint, the IP camera may not
transfer video to selected destinations simultaneously. Keep the number of
destinations as few as possible to avoid possible data loss.
Subject: This subject will appear as the subject when sending the motion detected
video or snapshot to email.
Interval: Each motion triggered in defined interval time. If you select "10 sec" here,
once the motion is detected and action is triggered, the next motion will be trigger
after 10 seconds. .
TV-IP343PI
28
Advertisement
Table of Contents
