Control Panel Programming - Bosch D9412G Installation Manual

D720 Series | Installation Guide | 7.0
7.0

Control panel programming

If you haven't created a program for the control panel,
review the appropriate program entry guide (refer to
Table 5 on page 5). Check to be certain you have all the
required accessory modules installed for the features
you want to use. Use the D5200 Programmer or the
RAM IV (RPS) remote programming software to load
your custom program into the panel.
7.1 Cmd Cntr Assignment
•
Keypad Addresses. There is no unique
programming required for the D720 Series. The
keypads may be used on any one of the keypad's
addresses. Bosch Security Systems recommends
not mixing D720 Series and other types of keypads
on the same address. The "keystrokes" used to
control the security system differ slightly between
keypad types, so that if two different types are on
the same address the end user could become
confused. For example, the user could become
confused by starting a Walk Test with one type of
keypad and then viewing untested points from
another type of keypad.
•
Supervision. Multiple D720 Series can be
installed on the same address when supervision is
set to NO. Only one D720 Series can be put at the
keypad address when supervision is set to YES.
•
Scope. The keypad scope must be set to "Area
Wide." The D720 Series does not support
"accounts" or "panel wide" scope selection.
•
Area Assignment. The D720 Series can be
assigned to any area.
7.2 Area Text
All programming within this section is not used by the
D720 Series.
6
Control panel programming
7.3
•
The D720 Series "A," "B," and "C" keys will
execute custom function numbers "128," "129,"
and "130," respectively:
The D9112 Program Entry Guide
(P/N: 71-06145-000) and D7212G Program Entry
Guide (P/N: 4998138538) explain the procedures
for proper programming of the "keystrokes" for
use with custom functions. There are some
differences between executing keystroke sequences
on a D720 Series as opposed to a D1255. The
keypad's [A],[B], and [C] keys execute custom
functions as if they were being executed from a
D1255.
•
The D720 Series does not have a Menu key to
bring up the "Command Menu."
No program entries are necessary in the
"Command Menu" section.
•
Point Assignment: The D720 Series' eight point
LEDs will be associated with the first eight points
assigned to the area in numerical sequence (not
including invisible points):
For example, if a D720 Series is to be used in area
3, and point numbers 21 through 28 are assigned
to area 3, then the D720 Series keypad LED #1
will reflect the state of point #21, LED #2 will
reflect the state of point #22, and so on.
•
Troubleshooting:
•
•
•
Custom Functions
Do not program more than eight points to any
area using a D720 Series for control. If more
than eight points are assigned to an area
controlled by a D720 Series, there will be no
indication of the ninth (or above) point in this
area.
Invisible points are not associated with any
LEDs.
If a point is one of the first eight assigned to an
area, and the point does not have a point
index number assigned, the LED will not light
for a fault or trouble, although the sounder will
annunciate the condition.
Bosch Security Systems | 8/04 | 74-06918-000-F