Adjusting With The Remote Control - NEC PX602UL-WH User Manual

Adjusting with the remote control

1. Hold the CTL button and press the ECO/L-SHIFT button.
The [LENS SHIFT] screen will be displayed.
2. Press the ▼▲◀ or ▶ button.
Use the ▼▲◀▶ buttons to move the projected image.
NOTE:
Lens Calibration
If the power of the projector is wrongly shut down during the motion of lens shift, it may shift the home position of the lens and
may cause of malfunction. In this case, perform lens calibration.
Lens calibration procedures
1. Power on the projector.
2. Press and hold the (CTL) button and press the (INFO/L-CALIB.) button on the remote control.
Calibration is performed.
TIP:
• The diagram below shows the lens shift adjustment range for the PX602UL-WH and PX602UL-BK (projection mode: desktop
front). To raise the projection position higher than this, use the tilt feet. (→ page 22)
• For the PX602WL-WH/PX602WL-BK and the ceiling mount/front projection lens shift adjustment range, see page 156.
* 30%V for the PX602WL-WH/PX602WL-BK.
Description of symbols: V indicates vertical (height of the projected image), H indicates horizontal (width of the projected image).
15%H
10%H
50%V
20%V*
100%V
20%V*
50%V
10%H 100%H
15%H
20
2. Projecting an Image (Basic Operation)
15%H
10%H
Width of projected image
20%V*
Height of projected image
20%V*
10%H
15%H