Adjusting With The Remote Control - NEC V230 User Manual

3. Projecting an Image (Basic Operation)

Adjusting with the remote control

1. Press the KEYSTONE button.
The Keystone bar will be displayed.
2. Use the  or  button to correct the keystone distortion.
Adjust so that the right and left sides are parallel.
3. Press the ENTER button.
NOTE:
• The Keystone correction can cause an image to be slightly blurred because the correction is made electronically.
• The maximum range of vertical keystone correction is +/−40 degrees. This maximum range may be smaller depending on the
signal or aspect ratio setting. The Keystone correction range will also be smaller when 3D mode is enabled.
• The range of keystone correction is not the maximum tilt angle of projector.
• The left and right (horizontal) keystone correction is not available.
TIP: The changes can be saved with [KEYSTONE SAVE]. (→ page 63)
26