Correcting Keystone Distortion
Correcting Keystone Distortion
If the screen is tilted vertically, keystone distortion becomes large. Proceed with the following
steps to correct keystone distortion
NOTE:
• The Keystone correction can cause an image to be slightly blurred because the correction is made electronically.
• The Keystone correction range can be made narrower, depending on a signal or its aspect ratio selection.
Adjusting with the remote control
1. Press the KEYSTONE button.
The Keystone bar will be displayed.
2. Use the or button to correct the keystone distortion.
Adjust so that the right and left sides are parallel.
3. Press the ENTER button.
NOTE:
• The Keystone correction can cause an image to be slightly blurred because the correction is made electronically.
• The maximum range of vertical keystone correction is +/−30 degrees. This maximum range can be changed depending on the
signal or aspect ratio setting.
• To reset the KEYSTONE correction setting values, press and hold the KEYSTONE button for a minimum of 2 seconds.
• The range of keystone correction is not the maximum tilt angle of projector.
• The left and right (horizontal) keystone correction is not available.
TIP: The changes can be saved with [KEYSTONE SAVE]. ( → page 63)
Downloaded From projector-manual.com NEC Manuals
3. Projecting an Image (Basic Operation)
28
POWER
ON
OFF
AUTO ADJ.
COMPUTER
1
2
3
VIDEO
S-VIDEO VIEWER
4
5
6
7
8
9
+
0
ID SET
CLEAR
AV-MUTE FREEZE
MENU
EXIT
ENTER
L
-
R
-
CLICK
CLICK
MOUSE
ECO MODEKEYSTONEPICTURE
VOL.
HELP FOCUS ASPECT
ZOOM
POWER
ON
OFF
AUTO ADJ.
COMPUTER
1
2
3
VIDEO
S-VIDEO VIEWER
4
5
6
7
8
9
+
ID SET
0
CLEAR
AV-MUTE FREEZE
MENU
EXIT
ENTER
POWER
ON
OFF
AUTO ADJ.
COMPUTER
1
2
3
L
-
R
-
CLICK
CLICK
VIDEO
S-VIDEO VIEWER
MOUSE
4
5
6
ECO MODEKEYSTONEPICTURE
7
8
9
VOL.
HELP FOCUS ASPECT
+
ID SET
0
CLEAR
ZOOM
AV-MUTE FREEZE
MENU
EXIT
ENTER
L
-
R
-
CLICK
CLICK
MOUSE
ECO MODEKEYSTONEPICTURE
VOL.
HELP FOCUS ASPECT
ZOOM