Panasonic BL-C30 Installation/Troubleshooting Manual page 29

Troubleshooting
Problem
Brightness is
not adjusted for
about half a
minute.
The image
refreshes very
slowly.
The image stops
refreshing
during the
wireless
communication
with the camera.
The camera
cannot
communicate
with the wireless
terminal.
• Brightness may not be adjusted for about half a minute, if the
brightness changes sharply.
Locate the camera where the brightness does not change
sharply.
• In very low light it is normal to see random colored noise on the
image.
As the light increases this will improve.
• Multiple users are accessing the camera.
If multiple users are accessing the camera, the image
refreshes slowly.
• You are not using an Ethernet switching hub.
If you view multiple cameras on the Multi-Camera page, the
image refreshes slowly. Use an Ethernet switching hub.
• The image may refresh slowly, depending on image resolution,
image quality, network traffic, PC performance or what object
you view.
• The Max. bandwidth usage is limited.
Increase the max. bandwidth usage on your network (see
page 31 of the Operating Instructions on the Setup CD-
ROM).
• The camera is in color night view mode.
The image refreshes slowly in color night view mode. Make
the area around the camera brighter.
• The image may stop refreshing because the wireless
communication can be disconnected depending on the
environment.
Click [Refresh] at the tool bar on the web browser.
• Radio waves may not be reaching the wireless terminal or the
camera due to the distance or the existence of obstacles such as
a concrete wall.
Put the wireless terminal near the camera.
Cause and Remedy
Installation/Troubleshooting
29