Starting And Stopping; How To Use - Flymo Micro Lite User Instructions

C
E
G
H
J

Starting and Stopping

D
F
1

How to Use

To Start your Product
1. Form loop in mains cable and push the loop
through the slot as illustrated in picture (C)
2. To secure, position loop over the hook and pull
the cable back through the slot as illustrated in
picture (D).
3. Connect plug to mains.
4. Move handle to the operating position. See Fig.
E.
5. To prevent a ring being cut in your lawn, tilt your
product slightly (E).
• The switchbox is provided with a lock-off button
(F1) to prevent accidental starting.
6. Press and hold the lock-off button (F) on the
switchbox, then squeeze one of the Start/Stop
levers towards the upper handle (G).
7. Continue to squeeze the start/stop lever towards
the upper handle and release the lock-off button.
(H)
8. When the product has reached full speed gently
lower it onto the lawn.
• NOTE
There are two start/stop levers fitted. Either one
can be used for starting the product.
• IMPORTANT
Do not use the start/stop levers intermittently
To Stop your Product
1. To prevent a ring being cut in your lawn, tilt your
product slightly (E).
2. Release the pressure on the Start/Stop lever.
1. Start cutting the edge of the lawn nearest to the
power point so that the cable is laid out on the
lawn you have already cut. (J)
2. Cut twice a week in the growing season, your
lawn will suffer if more than one third of its length
is cut at one time.
Do not Overload your Product
Cutting long thick grass may cause the motor
speed to drop, you will hear a change in the
motor sound. If the motor speed drops you may
overload your product which may cause damage.
When using in long thick grass, a first cut with the
cutting height set higher will help reduce the load.
See Adjusting the Cutting Height.