LG LSE3090ST Owner's Manual page 42

42
TROUBLESHOOTING
Problem
Food does not broil •
properly recommended.
- See the Using the Oven section, page 26.
• In some areas the power voltage may be low.
- Preheat the broil element for 5-7 minutes
- See the Broiling Guide, page 27.
Oven temperature too • Oven sensor needs to be adjusted.
hot or too cold - See Adjusting your Oven Temperature in the Features section.
Scratches or abrasions • Coarse particles such as salt or sand between cooktop and utensils can cause scratches.
on cooktop surface Be sure cooktop surface and bottoms of utensils are clean before usage. Small scratches do
• Cleaning materials not recommended for ceramic-glass cooktop have been used.
See CLEANING THE GLASS/CERAMIC COOKTOP in the CARE AND CLEANING section,
page 32.
Metal marks • Scraping of metal utensils on cooktop surface. Do not slide metal utensils on cooktop
surface. Use a ceramic-glass cooktop cleaning cream to remove the marks.
See CLEANING THE GLASS/CERAMIC COOKTOP in the CARE AND CLEANING section,
page 32.
Brown streaks or specks • Boilovers are cooked onto surface. Use the blade scraper to remove soil.
See CLEANING THE GLASS/CERAMIC COOKTOP in the CARE AND CLEANING section,
page 32.
Areas of discoloration • Mineral deposits from water and food. Remove using a ceramic-glass cooktop cleaning
with metallic sheen cream. Use cookware with clean, dry bottoms.
Oven will not self clean • The oven temperature is too high to set a self clean operation.
- Allow the range to cool and reset the controls.
• Oven controls improperly set.
- See the Self Clean section, page 34.
• A self clean cycle cannot be started if the oven lockout feature is active.
"Crackling" or "popping" • This is the sound of the metal heating and cooling during both the cooking and Self Clean
sound functions.
- This is normal.
Fan noise
- This is normal.
• Apply a small amount of vegetable oil to a paper towel and wipe the edges of the oven
to slide racks with the paper towel.
Convection fan stops • Convection fan stops during a convection bake cycle.
- This is normal and is done to allow for more even heating during the cycle.
This is not a failure of the range and should be considered normal operation.
Possible Causes / Solutions