Panasonic KX-FT901CX-B Service Manual page 118

KX-FT901CX-B / KX-FT903CX-B / KX-FT901CX-W / KX-FT903CX-W / KX-FT901CX-S / KX-FT903CX-S
8.4.5. STEPPING MOTOR DRIVE CIRCUIT
1. Function
One individual stepping motor is used for transmission and reception. It feeds the document or recording paper synchronized
for reading or printing.
2. Circuit Operation
During motor drive, gate array IC1 pin 124 becomes a high level, and Q4 and Q1 go ON as a result. +24 V is supplied to the
motor coil.
Stepping pulses are output from gate array IC1, causing driver IC7 to go ON. The motor coil is energized sequentially in 2 phase
increments or 1-2 phase increments, which causes a 1-step rotation. A 1-step rotation is 0.13mm of recording paper or
document paper. The timing chart is below.
When the motor is OFF, gate array IC1 pin 124 becomes a low level and Q4 and Q1 also turns OFF. Instead of +24V, +5V is
supplied through D1 so that the motor is held in place.
Stepping Motor Phase Pattern
Function Mode
Copy Fine/Half Tone
Super Fine
FAX STD
Fine/Half Tone
Super Fine
——— Paper Feed
Phase Pattern
1-2 432 pps
1-2 216 pps
2 432 pps
1-2 432 pps
1-2 216 pps
2 432 pps
118
Speed