Vertex Standard VX-2100 Operating Manual page 13

c S
hannel can
The Scanning feature is used to monitor multiple channels programmed into the
transceiver. While scanning, the transceiver will check each channel for the pres-
ence of a signal, and will stop on a channel if a signal is present.
To activate scanning:
 Press (or press and hold) the assigned programmable key to activate scanning
on the current group.
 The scanner will search the programmed channels, looking for active ones; it
will pause each time it finds a channel on which someone is speaking.
 Press (or press and hold) the assigned programmable key again to disable
scanning. Operation will revert to the programmed revert channel.
Note: Your dealer may have programmed your radio to stay on one of the fol-
lowing channels:
 Current channel ("Talk Back")
 "Last Busy" channel
 "Priority" channel
 "Scan Start" channel
Scan Set
Press (or press and hold) the assigned programmable key to delete the Current
Memory channel from the Scanning.
In the VX-2100 , when you delete a channel, the decimal point " . " will disappear
from the Channel Number Indicator. To restore a particular channel to your scan-
ning list, press (or press and hold) the assigned programmable key again; the deci-
mal point " . " will appear on the Channel Number Indicator.
In the VX-2200 , when you delete a Group or channel, " - SKIP - " will appear on
the LCD for one second after pressing the assigned programmable key. To restore
a particular channel to your scanning list, press (or press and hold) the assigned
programmable key again; " - STOP - " will appear on the LCD for one second after
pressing the assigned programmable key.
VX-2100/-2200 S
a
dVanced
( Scan )
O
erieS perating
O
peratiOn
M
anual
11