Table of Contents
Advertisement
⁄6
Height Adjustment
Height adjustment should always be performed by at least 2 persons.
To adjust the height of the tone bars, first remove the round belt (fan belt), driver, controller and tone
bars*, and loosen the center rod fixing bolts. (* To remove the tone bars, disengage the springs on
the low sound side, and then unhook the string from the post.)
Support both frame ends by hand (do not touch the metal parts shown in the illustration), and loosen
the slide leg fixing bolts.
Lift the frame ends to the desired height and then securely tighten each slide leg fixing bolt, aligning
it with the corresponding notch of the slide leg. Bolt and notch are aligned when the next higher notch
is flush with the upper leg flange. (Refer to step
When a slide leg fixing bolt is tightened in between two notches,
there is a danger of the slide leg slipping. Always make sure
that the slide legs are held securely.
⁄7
This completes the assembly of the instrument.
To play, connect the supplied AC adapter to the DC 12-15V IN jack of the controller.
Frame
Do not touch !
For height adjustment, make
sure to support the instrument
by the wooden frame. Do not
touch the metal parts.
m
on page 24.)
Assembly
29
Advertisement
Table of Contents
