Installer Setting - Zone Number Setting - Friedrich DWC1 Installation And Operation Manual

Installation instruction

Installer Setting - Zone Number Setting

This function is only available on some products.
Zone Number is to set the number of installed zones. It's possible to control only in zone new type
20 DWC1 Programmable Thermostat
If pressing button long for 3
1
seconds, it enters into remote
controller setter setup mode.
- If pressing once shortly, it enters
into user setup mode. Please press
more than 3 seconds for sure.
Repeat pressing
2
Function code 14.
Function Code
Ex) Setting the Zone Number for "2"
Select Zone Number by pressing
3
button
(02~04 : number of zone installed)
Press button to save or release.
4
Press button to exit or
5
system will automatically exit
after 25 seconds without any
input.
button to select
Zone Number installed