Related Manuals for Friedrich KWW
Summary of Contents for Friedrich KWW
- Page 1 This Manual covers the following models: KWW– Kühl Wireless Wall Thermostat KCM– Kühl Communication Module 930-01-005 (4/8)
- Page 2 Puts thermostat into temperature the program setup Momentary Fan operating status backlight button Fan control Changes operating mode HEAT, COOL, Changes Set Point temp - Also used in clock and program setup Push button for pairing with KWW 930-01-005 (4/8)
- Page 3 6. When the wall thermostat is used with your Kühl unit you have the option to have the unit display continue to light up as it does without the KWW thermostat or, you may configure the unit so the display is inactive and only the communication symbol will illuminate .
- Page 4 Step 2: Install KCW into your Kühl air conditioner Turn off power to unit at power button Open the filter panel on front of Kühl unit (Fig 3) Locate control board at the left side of unit (Fig 5) ...
- Page 5 To open KWW’s housing press in tabs at bottom and pull apart the housing (Fig 9) Install (4) AA batteries into KWW (Fig 10) Fig 9 Tabs Backplate removed Fig 10 Thermostat will operate on either battery Set A, Set B or both.
- Page 6 KWW’s display and the Install icon will blink. Next press the HEAT/COOL button once and let go. The default number 00 will flash on the KWW’s display. (*Note: For multiple KCM’s set 01,02 etc, as more KCM’s are added) ...
-
Page 7: Step 4: Mounting The Thermostat
Note: Mount the thermostat about five feet above the floor. Do not mount the thermostat on an outside wall, in direct sunlight, behind a door, or in an area affected by a vent or duct. The KWW has six (6) mounting holes. Back plate will match up with existing electrical box or drywall mounting ring. - Page 8 Note: When “OFF” appears on the display of the KWW the system has turned off based on the set point. In manual mode you can adjust to the desired temperature using the UP and DOWN buttons, and the thermostat will maintain that temperature until you change it again.
-
Page 9: Setting The Clock
Thermostat Programming: The Friedrich Kuhl thermostat provides four program periods: Morning, Day, Evening, and Night. The time and temperature can be set for each period. *Separate heating and cooling programs can be entered. Upon initial power up the thermostat loads time and temperature program default parameters for weekday and weekend days. -
Page 10: Exiting Program Mode
Cont’ Thermostat Programming: The mode the thermostat is in when the PROGRAM or RUN button is pressed is the mode that will be controlled by that program. If in the COOL mode as shown, the program entered will be stored as the program for cooling. The mode displayed on the screen is the mode that will run. - Page 11 Energy Star guidelines and are a good point from which to start. Default settings are provided in (Fig 16) Contact Us: Friedrich Air Conditioning 10001 Reunion Place, Ste. 500 San Antonio, TX 78216 Toll Free: 1-800-541-6645 www.friedrich.com 930-01-005 (4/8)