Gigabyte GA-990FXA-UD5 User Manual page 84

For the Marvell 88SE9172:
Step 1:
Copy the Marvell folder under BootDrv in the driver disk.
Step 2:
Boot from the Windows 7 setup disk and perform standard OS installation steps. When the screen requesting
you to load the driver appears, select Browse.
Step 3:
Insert the motherboard driver disk and then browse to the location of the driver. The locations of the drivers
are as follows:
RAID driver for Windows 32-bit: \BootDrv\Marvell\RAID\i386
RAID driver for Windows 64-bit: \BootDrv\Marvell\RAID\amd64
AHCI driver for Windows 32-bit: \BootDrv\Marvell\AHCI\Floppy32
AHCI driver for Windows 64-bit: \BootDrv\Marvell\AHCI\Floppy64
Step 4:
When a screen as shown in Figure 2 appears, select Marvell 91xx SATA 6G RAID Controller and click Next
to load the driver and continue the OS installation
Appendix
Figure 2
- 84 -