Table of Contents
Advertisement
9. Programmable Features
Feature/Code
Sending a fax at a specific
time
{#}{4}{1}{2}
Setting the Error Correction
Mode (ECM)
{#}{4}{1}{3}
Setting the connecting tone
{#}{4}{1}{6}
Setting auto reduction
feature
{#}{4}{3}{2}
54
Selection
This feature allows you to take advantage of low-cost calling hours offered by
your telephone company. This feature can be set up to 24 hours in advance of
the desired time.
{0} "OFF" (default)
{1} "ON"
To send a document:
1. If the {Fax} light is OFF, turn it ON by pressing {Fax}.
2. Set the original (page 19).
3. If necessary, change to the desired resolution (page 38) and the desired
contrast (page 38).
4. {Menu} i {#}{4}{1}{2}
5. Press {1} to select "ON". i {Set}
6. Enter the fax number.
L To enter an item using one-touch dial feature and navigator directory,
see step 3 on "7.2 Sending a fax using one-touch dial feature and
navigator directory", page 39. (When using navigator directory, you do
not have to press {Directory} before pressing {V} or {^}.)
7. {Set}
8. Enter the transmission start time.
L If you selected 12-hour time entry (page 21), press {*} repeatedly to
select AM or PM.
L If you selected 24-hour time entry (page 21), the time is set using 24-
hour time entry.
9. {Set}
L The document will be fed into the unit and scanned into memory. The
unit will then send the data at the specified time. You cannot use this
feature for another fax transmission until the former sending is
completed.
Note:
L To cancel after programming, press {Stop} while the unit is idle, and then
press {Set}.
This feature is available when the sending / receiving fax machines are ECM
compatible.
{0} "OFF": Deactivates this feature.
{1} "ON" (default): If there is an error during fax transmission / reception, the
unit will support the communication.
If you often have trouble when sending faxes, this feature allows you to hear
connecting tones: fax tone, ring back tone and busy tone. You can use these
tones to confirm the status of the other party's machine.
{0} "OFF": Deactivates this feature.
{1} "ON" (default): You will hear connecting tones.
Note:
L If the ring back tone continues, the other party's machine may not be a fax
machine or may have run out of paper. Check with the other party.
L The connecting tone volume cannot be adjusted.
To receive a fax document that is longer than your recording paper.
{0} "OFF": The unit will print the original size.
{1} "ON" (default): The unit will fit received documents onto your recording
paper.
Advertisement
Table of Contents
