Set Up New Printer Screen Is Displayed; Glossary; Dhcp Function; Ip Address - Canon Pixma Pro-1 series Getting Started

3
When the Disconnect Cable screen appears, remove the USB cable, then click
Next.
The wired connection setup of the printer is now complete. Click Complete or OK.
• Proceed with the setup by following the procedures from "Information" (Windows) or "Registration
(Macintosh)" (Macintosh) in the printed manual: Getting Started.

Glossary

•

DHCP function

A function to automatically assign required information (IP address, etc.) to computers, printers or other
devices connected to the network.
•

IP address

A numerical identification assigned to each computer or network device connected to a network.

Set Up New Printer Screen is Displayed

Check
A D
Check 1
Make sure that you follow "Connection Checklist" on page 7, then click Redetect (A).
Check 2
Turn off the network device (router, etc.), turn it back on, then click Redetect (A).
Check 3
Make sure that the DHCP function of the network device (router, etc.) is active.
• To specify the IP address, set up a wired connection using a USB cable. Go to
the Printer's IP Address" on page 5.
• For details on how to check settings of the network device, refer to the manual supplied with the
network device or contact its manufacturer.
Activate the DHCP function of the network device, then click Redetect (A).
• For details on how to change settings of the network device, refer to the manual supplied with the
network device or contact its manufacturer.
Check 4
Is the printer connected to a network?
• To check if the printer is connected to a
network, print the Network Configuration
Page, then make sure that Link Status is set
to Active. To print the Network Configuration
Page, hold down the RESUME/CANCEL
button (B) on the printer until the POWER
lamp (C) flashes 6 times, then release the
RESUME/CANCEL button after the sixth
flash.
A D
If the printer is not connected to a network, perform setup again by following the
procedures from "Set Up a Wired Connection" in the printed manual: Getting Started.
Check 5
If the printer is not detected, set up a wired connection using a USB cable. Perform the
following procedure.
1
Click Next (D).
in "Specifying
B
C
3