Settings; Setting The Beep Function - Icom IC-F29SR Operating Instructions Manual

4
Section

Setting the Beep function

The Beep function can be turned ON or OFF. When it is
OFF, the channel announcement is also turned OFF.
NOTE: You should turn ON the Beep function when
you set the microphone gain, the squelch level or the
group code number to check the current level setting
with the beep sounding. (pp. 8–11)
[VOL] to turn OFF the transceiver power.
Rotate
q
[ROTARY SELECTOR] to any channel other
Set
w
than Channel 16.
While holding down [Lower], rotate [VOL] to turn ON
e
the power to enter the Beep level adjustment mode.
Push [Lower] to turn the Beep function ON or OFF.
r
• When a beep sounds after pushing [Lower], the Beep
function is ON. When no beep sounds after pushing
[Lower], the Beep function is OFF.
• If desired, push [Upper] to adjust the Beep level. See
page 6 for details.
Rotate [VOL] to turn OFF the power to exit the Beep
t
level adjustment mode.

SETTINGS

[Upper]
[Lower]
5
[ROTARY SELECTOR]
[VOL]