Crossover Network Setup - Kenwood KVT-617DVD Instruction Manual

Crossover Network Setup

You can set a crossover frequency of speakers.
X'Over Setup screen
X ' O v e r
HPF Front FREQ
1
HPF Rear FREQ
2
LPF SUB FREQ
3
4
S U B P h a s e
1 Sets a Front High Pass Filter frequency.
You can select any of the following frequency.
Through, 40, 60, 80, 100, 120, 150, 180, 220 Hz
2 Sets a Rear High Pass Filter frequency.
You can select any of the following frequency.
Through, 40, 60, 80, 100, 120, 150, 180, 220 Hz
3 Sets a Subwoofer Low Pass Filter frequency.
You can select any of the following frequency.
50, 60, 80, 100, 120, Through Hz
4 Sets the phase of subwoofer output.
The phase is reversed 180 degrees when set to
"Reverse".
5 Returns to the Speaker setup screen.
• Set in both the front channel and rear channel
simultaneously when using high pass filter function. You
cannot set a correct crossover network if the high pass filter
function is used for one channel only.
• The SUB Phase button is not displayed when the Sub-
woofer Low Pass Filter is set to "Through".
62
|
English
(Page 61 5)
2 2 0 H z
1 8 0 H z
1 2 0 H z
N o r m a l
5
Re t u r n