Operation Of Remote Control Unit - Kenwood XD-980MD Instruction Manual

Operation of remote control unit

Loading batteries
1 Remove the cover.
Operation
After plugging the power cord of this unit, press the ON/
STANDBY ( ) key of the remote control unit to turn the
system ON. When the system is turned ON, press the key
of the function to be operated.
Press the ON/STANDBY (
time display will remain lit and standby status will be
reached.
When pressing more than one remote control keys successively,
press the keys securely by leaving an interval of 1 second or more
between keys.
1. The provided batteries are intended for use in operation checking, and their service life may be short.
2. When the remote controllable distance becomes short, replace both of the batteries with new ones.
Notes Notes
3. If direct sunlight or the light of a high- frequency fluorescent lamp (inverter type, etc.) is incident to the remote sensor, malfunction may occur.
In such a case, change the installation position to avoid malfunction.
2 Insert batteries.
Insert two R6 ("AA"-size) batteries following the polarity indications.
) key again for OFF. Only the
9
(
( ( (
9 9 9
30
Model: RC-H9R
Infrared ray system
Controls and indicators
XD-980MD (En)
3 Close the cover.
2
1
Remote sensor
6 m
30
Operating range (approx.)
1 5