Mazda 2015 5 Owner's Manual page 260

Interior Comfort
Bluetooth® Audio
NOTE
®
Some Bluetooth audio devices need a
l
certain amount of time before the "
symbol is displayed.
If the programming failed, "Err" flashes
l
for three seconds then it returns to
"PAIR DEVICE".
Programming cannot be performed while
l
the vehicle is moving. If you attempt to
perform programming while the vehicle is
moving, "PAIR DISABLE" is displayed and
it returns to "PAIR DEVICE".
®
If seven Bluetooth
l
already been programmed to the vehicle,
programming cannot be performed and
"MEMORY FULL" is displayed. Delete
one programmed device to program
another one.
Programming a Bluetooth
device which does not have a four-digit
PIN code
1. Using the audio control dial, select the
pairing program mode
PAIR DEVICE in the BT SETUP
mode. (Refer to Bluetooth
up for details.)
2. Press the audio control dial to
determine the mode.
After ENTER PIN is displayed on
the information display for three
seconds, PIN 0000 is displayed and
the PIN code can be input.
3. Press the audio control dial while
PIN 0000 is displayed.
PAIRING flashes on the display.
4. Operate the Bluetooth
and set it to the program mode while
PAIRING is flashing.
®
5. As the Bluetooth
requires a PIN code, input 0000 .
6-64
"
audio devices have
®
audio
®
audio set
®
audio device
audio device
6. When the programming is completed,
and PAIR SUCCESS are
displayed after about 10-30 seconds,
after which PAIR SUCCESS
continues to be displayed for three
seconds, and then the unit returns to the
normal display.
NOTE
If pairing cannot be completed, try "1234"
l
instead. Refer to the owner's manual of
your mobile device for the right PIN code.
®
Some Bluetooth audio devices need a
l
certain amount of time before the "
symbol is displayed.
If the programming failed, "Err" flashes
l
for three seconds then it returns to
"PAIR DEVICE".
Programming cannot be performed while
l
the vehicle is moving. If you attempt to
perform programming while the vehicle is
moving, "PAIR DISABLE" is displayed and
it returns to "PAIR DEVICE".
®
If seven Bluetooth
l
already been programmed to the vehicle,
programming cannot be performed and
"MEMORY FULL" is displayed. Delete
one programmed device to program
another one.
"
audio devices have