Problem Solving Guide; Check And Fault Messages - Miele TDA 150 Operating Instructions Manual

Problem solving guide

With the help of the following notes minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be put right
without contacting the Service Department.

Repair work to electrical appliances must only be carried out by a suitably
qualified person in strict accordance with current local and national safety
regulations. Repairs and other work by unqualified persons could be
dangerous. The manufacturer cannot be held liable for unauthorised work.

Check and fault messages

Problem
The Empty container
indicator lights up. The
programme is
cancelled, the buzzer
sounds.
The programme is
cancelled.
The buzzer may sound
and the Clean out
airways or Empty
container indicator
flashes.
The programme is
cancelled,  lights up
30
Cause and remedy
The condensed water container is full or there is kink
in the drain hose.
 Empty the container.
 Check the drain hose.
 Open and close the door while the dryer is
switched on. The indicator light will go out.
No obvious cause.
 Switch the dryer off and then on again.
 Start a programme.
If the programme is cancelled again and a fault
message appears, there is a fault. Contact Miele
service.
This is not a fault.
In some programmes, if the drum has been
underloaded or is empty, the programme will be
cancelled. This can also happen if the items are
already dry.
 Open and close the door to resume drying.
 Dry individual items using the Warm air timed
drying programme.