Preparing The Remote Control (Rc-R0710); Preparing For Surround Sound; Speaker Settings; In Case Of Difficulty - Kenwood KRF-V5020 Instruction Manual

Preparing the remote control (RC-R0710)

Loading the batteries
1 Remove the cover.
3 Close the cover.
• Insert two AA-size (R6) batteries as indicated by the polarity mark-
ings.
Operation
When the STANDBY indicator is lit, the power turns ON when you press
the POWER key on the remote control. When the power comes ON,
press the key you want to operate.
Operating range
(Approx.)
6 m
30˚ 30˚
Model: RC-R0710
Infrared ray system
• When pressing more than one remote control key successively,
press the keys securely by leaving an interval of 1 second or more
between keys.
Notes
1. The supplied batteries may have shorter lives than ordinary batteries
due to use during operation checks.
2. When the remote-controllable distance gets shorter than before,
replace both batteries with new ones.
3. Placing the remote sensor in direct sunlight, or in direct light from a
high frequency fluorescent lamp may cause a malfunction.
In such a case, change the location of the system installation to
prevent malfunction.
Setting up the system
2 Insert the batteries.
Remote sensor

Preparing for surround sound

Speaker settings

To enable you to obtain optimum enjoyment from the receiver's
listening modes, make sure to complete the speaker settings as
described below.
SETUP
VIDEO
TUNING/SKIP
SETUP
RC-R0508
1
Turn on the receiver.
2
Select a speaker system.
1 Press the SETUP key to make the subwoofer setting indica-
tion (SUBW) appear.
SP A
s UBW
2 Use the MULTI CONTROL (TUNING/SKIP) to select the ap-
propriate subwoofer setting.
1 SUBW YES: A subwoofer is connected to the receiver.
2 SUBW NO: No subwoofer is connected to the receiver.
3 Press the SETUP key to accept the setting.
• The center speaker setting indication (CNTR) appears.
SP A
C NTR
4 Use the MULTI CONTROL (TUNING/SKIP) to select the ap-
propriate center speaker setting.
1 CNTR NML (normal):
2 CNTR LRG (large):
3 CNTR NO:
5 Press the SETUP key to accept the setting.
• The surround speaker setting indication (SURR) appears.
6 Use the MULTI CONTROL (TUNING/SKIP) to select the ap-
propriate surround speaker setting.
1 SURR YES: Surround speakers are connected to the re-
ceiver.
2 SURR NO:
No surround speakers are connected to the
receiver.
7 Press the SETUP key to accept the setting.
• The receiver enters the speaker volume level adjustment mode.
• In steps 3 and 4, indications appear only for the selected
channels of the speakers that require adjusting.
KRF-V7020/V6020/V5020 (En/T)
MULTI CONTROL
MULTI CONTROL
SETUP
RC-R0710
$
Y Es
STEREO
N ML
STEREO
An average size center speaker is
connected to the receiver.
A large center speaker is connected
to the receiver.
No center speaker is connected to
the receiver.
Continued to next page
13