Adjustments For Surround Play - Kenwood KR-797 Instruction Manual

To improve the feeling of presence in the surround modes,
various parameters of each surround mode can be set up
24
according to the speaker system used as well as to the
environmental of the listening room. The following proce-
dure let you set the parameters of the surround mode (DOLBY
PRO LOGIC, DOLBY 3 STEREO).
Once the settings have been done, it is held in memory so re-
adjustment is not necessary even after the mode has been
changed to other modes.

Adjustments for surround play

1
Select the DOLBY PRO LOGIC surround mode.
2
Select the CENTER MODE.
3
Adjust the front speaker balance.
1 Press the SETUP key (on the remote con-
2 Adjust the front speaker (left & right)
3 Press the SETUP key again to establish
PRO LOGIC
CENTER
MODE
trol unit).
SETUP
levels so that the left and right levels are
identical.
To decrease the
left channel sound
LEVEL
CONTROL
To decrease the
right channel sound
the setup.
After this, the unit enters the condition
for "4 Adjust the volume level of each
speaker".
1 2 3 POWER
4 5 6 0
7 8 9 +10
7 2 6
DISK SKIP
A/B +100 AUTO BAND
1 ¡ 4 ¢
AUDIO-VIDEO SURROUND RECEIVER KR-897
P.CALL
VIDEO1
TAPE1 TUNER CD PHONO
STANDBY
TAPE2
POWER
VIDEO2 MONITOR AV AUX MUTE
1
CENTER LISTEN
ON/STANDBY
MODE MODE
LEVEL VOLUME
CONTROL
SETUP CONTROL SOUND
PHONES
REMOTE CONTROL UNIT
SPEAKERS
RC-R0505
: Keys or controls to be used in this operation
÷ Select a surround mode according to the played source and your
system components.
P R O L O G I C
Each press of CENTER MODE key switches the modes as follows:
1 NORMAL
: When the center speaker is a compact
speaker.
2 WIDEBAND : When the center speaker is a large speaker.
3 PHANTOM : When no center speaker is used.
Adjustment procedure: Each press of the SETUP key switches the
adjusted items as shown below.
3 Adjusting the front speaker balance
4 Adjusting the volume level of each speaker
5 Adjusting the delay time
End of setup
To cancel setup in the middle, press the SETUP key repeatedly until the
setup mode is cancelled.
Left speaker Center position
position indication
- - - y - -
Balance setup
KR-897/KR-797 (En)
PRO LOGIC 3 STEREO
SRS
3D SPEAKERS
STEREO SRS 3D
INPUT SELECTOR VOLUME CONTROL
SOURCE
N.B.
DIRECT
2 3 4 5 6 7 8 9 0 +10
TAPE2
TUNING
AUTO DIRECT MEMORY BAND DIMMER MONITOR P.CALL
DOWN
Lights
SURROUND
Right speaker
position
SURROUND
t
UP