Recordin - Kenwood KR-797 Instruction Manual

Recording
When recording sound with a recorder component of KENWOOD, synchro recording is possible by setting the INPUT SELECTOR
to select TAPE1 or MD according to the connected component.
18
Preparation
÷ Switch the TAPE1 display to MD or VIDEO1 with the following
operation.
1 Select TAPE1 with the INPUT SELECTOR.
2 Press and hold the AUTO key for more than 2 seconds.
To record a music source
1 Select the source to be recorded.
2 Put the cassette deck in record-pause
3 Play the source and start recording.
Copying tape (Tape dubbing TAPE 2 = TAPE 1)
1 Press the TAPE 2 MONITOR key.
2 Select a source other than TAPE 1.
3 Play cassette deck 2 and start recording
Copying tape (Tape dubbing TAPE 1 = TAPE 2)
1 Select TAPE 1 with the INPUT SELECTOR control of the
main unit.
2 Play the cassette deck connected to the TAPE 1 jacks and
start recording of the cassette deck connected to the
TAPE 2 jacks.
Regarding TAPE 2 MONITOR
A cassette deck or graphic equalizer can be connected to this unit's TAPE 2 MONITOR terminals. If you connect a graphic equalizer, turn the
TAPE 2 MONITOR key ON. If you connect a 3-head cassette deck, you can monitor the source sound, or the sound being recorded, while
recording. Pressing the TAPE 2 MONITOR key lets you compare the recorded sound and the source sound. Refer to the operating manual for
the component you connected for further details.
INPUT SELECTOR
Select an input
source other than
TAPE 1.
mode.
TAPE2
TUNING
BAND DISPLAY MONITOR
INPUT SELECTOR
on cassette deck 1.
Each press switches the display.
1 TAPE1 2 MD
The input sources are switched in the following order:
1 TUNER (frequency display)
2 PHONO
3 TAPE1 (MD or VIDEO1)
4 CD
5 VIDEO2
÷ The VIDEO1 display can be switched to the display of other input by
using the procedure described in "Preparation" above.
÷ For the synchro recording with a cassette deck and/or MD recorder,
refer to the respective instruction manuals..
÷ It is not possible the VIDEO1 or MD input to TAPE1 because all of these
components should use the same INPUT SELECTOR position.
Lights
TAPE 2 C D
÷ For copying a tape using a double cassette deck, read the instruction
manual of the double cassette deck.
KR-897/KR-797 (En)
3 VIDEO1